The rubber glazing channel can not be pulled too tightly, and the length of the blanking is 2O-3Omm longer than the assembly length. It should be set in place during installation, the surface is straight, and it is in close contact with the glass and glass slot, so that the surrounding force of the glass is evenly distributed. At the corner, the rubber strip should be beveled off and glued firmly at the break.
When sealing the glass with sealant, the glass should be squeezed with rubber strips or rubber blocks to leave a gap of glue injection. The depth of glue injection should be no less than 5mm. Before the glue is cured, the glass should be kept from vibration.
The installation position of the top is generally on the window (door) fan, around the frame fan or on the sealing bridge (wind block), and the seal between the frame and the fan is strengthened.
The top specification is an important factor affecting the sliding door and window and watertight performance, but also an important factor affecting the door and window switching force. If the top size is too large or the vertical hair is too high, not only the assembly is difficult, but also the resistance of the door and window is increased, especially the initial resistance at the time of opening and the final seating resistance at the time of closing.
The specification is too small, or the height of the vertical top is not enough, easy to get out of the slot, so that the sealing performance of the door and window greatly reduces the picture of the workbench. The tops are subjected to silicidation. The quality of the tops is flat, the bottom and vertical are smooth, no bending, and there is no pitting on the bottom, which meets the requirements of 0.2mm.
As a China glazing channel factory, Hellorubber can make the seals according to the drawing or samples. Please contact us for details.